Parts & Accessories


GRIPS

  • Adds no length or width to pistol
  • Requires matching of frame
  • Attaches with (4) heat treated screws, each with a tensile strength of 125,000 P.S.I
  • Can be enlarged into mainspring housing

Available in blue or stainless with various grips (listed below)

  • Hogue Checkered Coco-Bolo Grips
  • Navidrex Checkered Black Micarta
  • Aluma-Grips, Black

Typical Installation On Stainless Pistol

 

LIGHTWEIGHT ALUMINUM TRIGGER – INTERNALLY LIGHTENED

This is a solid Videki trigger that has been lightened per Heinie specification, as Richard has been doing since the mid 1970′s. As requested by most custom pistolsmiths, the trigger is supplied with an over-travel screw. Heinie recommends securing this screw with red loctite, epoxy, or black max adhesive. This trigger and set screw together weigh only 96.6 grains. $29.20

 

#630 TRIGGER/BOLT SPRING FOR SINGLE ACTION ARMY PISTOLS

Warning: Installation of this spring can cause dangerously light trigger pull. This spring should be installed only by a competent pistolsmith, in conjunction with an action job.


© Copyright 2018 Heinie Specialty Products, Inc., All Rights Reserved Website Developed by PyroGraphics
Heinie Specialty Products, Inc.
301 Oak Street
Quincy, IL 62301
217-228-9500