Heinie Specialty Products

Parts

Online Store/Ordering & Prices

Sights

Sight Installation Prices

Heinie Parts & Accessories

Heinie Mag Well...In Stock Now!!		(Shown w/Coco-Bolo Grips)
		* Adds no length or width to pistol. * Requires machining of frame. * Attaches with (4) heat treated screws, each with a tensil strength of 125,000 P.S.I.. * Can be enlarged into mainspring housing. * Available in blue or stainless w/VARIOUS GRIPS (LISTED BELOW) * Kit comes with machining dimensions with X&Y coordinates.
#615	Heinies "XX" Mag Well Kit (Blue) w/Grips	$149.95
#616	Heinies "XX" Mag Well Kit (Stainless) w/Grips	$149.95

	Hogue Checkered Coco-Bolo Grips	- NOW IN STOCK
	Navidrex Checkered Black Micarta	- NOW IN STOCK
	Aluma-Grips, Black	- NOW IN STOCK

Typical Installation on Stainless Pistol

	Lightweight Aluminum Trigger - Internally Lightened

	This is a solid Videki trigger that has been lightened per my specification, as I have been doing since the mid 1970's. As requested by most custom pistolsmiths, the trigger is supplied with an over-travel screw. I recommend securing this screw with red loctite, epoxy, or black max adhesive. This trigger and set screw together weigh only 96.6 grains. $29.20

#630 Trigger/Bolt Spring for Single Action Army Pistols

Warning: Installation of this spring can cause dangerously light trigger pull. This spring should be installed only by a competent pistolsmith, in conjunction with an action job.